[Boro Format] NTSU Boro Plus+ Boro Tank (Bridge Coil/RBA Bridge Boro Pod) (1 Pack)

0 Rating
49,00 €
SKU: VD-2642

The NTSU Boro Plus+ Boro Tank is designed for Boro format Pod Mod Systems.

It is compatible with Bridge Coil Adapters and Standalone BB RBA Bridges.

Variants:
Clear PC1000: Made from solid block of PC1000

Grigio Nardo: Made from solid block of Grey Delrin

Natural Peek: Made from solid block of Natural Peek

Night Black: Made from solid block of Black Delrin

Product Specifications:
NTSU Boro Plus+ Boro Tank
Refillable Pod (Capacity Depending On The Bridge Used)
Side Refill System - Sliding Glass
Adjustable Airflow Control - Interchangeable Airflow Pins

Compatible Devices:
Consult the Boro Format Pod Family at the Pod Systems Using The Same Pods Category

Compatible Coils:
Supports a variety of coils depended on the Bridge Coil Adapter used

Compatible Bridge Coil Adapters:
Consult the Boro Format Bridge Coil Adapters List at the Bridge Coil Adapters Category

Compatible RBA Bridges:
Consult the Boro Format RBA Bridges List at the RBA Bridges Category

Compatible Pods:
Consult the Boro Format Pod Family at the Pod Families (Info) Category

* RBA Bridges are not suitable for use by those who do not have an understanding of battery safety, Ohms Law & rebuilding

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Attach the coil to the Bridge Coil Adapter, fit the Bridge Coil Adapter into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.

There are yet no reviews for this product.

Please log in to write a review. Log in