REPLACEMENT COILS
* For RBA Coils, visit the RBA Coils Category (You can also find them here though)
Factory coils (Aka "Also known as" Drop-in Coils / Stock Coils) which are applied to Tanks, Pods, Pod Tanks, Bridge Coil Adapters.
Warning: DO NOT use Standard Tanks with Faux Hybrid Mechanical Mods or a hard short might occur which can result in the battery bursting.
Note: We recommend using high VG e-liquids of 60% and up to 80% with low resistance stock coils (0.1ohm up to 0.7ohm) for best performance.
Due to the larger amounts of vapor that is created, we advise that you do not use an e-liquid that has higher than 10mg/ml nicotine strength.
With high resistance stock coils (Above 0.8ohm) we recommend using high PG e-liquids of 50% and above for best performance.
If your device supports TC Mode / TCR Mode, choose the proper TC Mode or set the proper TCR value if you want to try temperature control vaping.
• If TCR value you set is higher than actual, you'll burn the coil(s).
• If TCR value you set is lower than actual, the atomizer won't vaporize properly.
• If a wrong TC Mode is chosen, either the atomizer won't vaporize properly (Lack of vapor) or you'll burn the coil(s).
Use extreme caution using Ni200 or Ti1 coils. If you burn them you'll inhale some very TOXIC fumes.
Temperature control mode was developed to stop the occurrence of burnt coils or 'dry hits'.
Temperature Control capable devices measure the changes in your coil's resistance and assign a temperature value to them.
You can set a maximum temperature your coils will reach and your device will alter the power output to ensure that your coils never reach beyond the set limit.
TCR VALUES (ppm change in electrical resistance per degree of temperature change)
Alloy: SS316L TCR: 0.000879 (Set 0087 for a 4 digit screen display - 087 for a 3 digit screen display)
Alloy: SS316 TCR: 0.000880 (Set 0088 for a 4 digit screen display - 088 for a 3 digit screen display)
Alloy: SS304 TCR: 0.001010 (Set 0101 for a 4 digit screen display - 101 for a 3 digit screen display)
Alloy: SS317L TCR: 0.000940 (Set 0094 for a 4 digit screen display - 094 for a 3 digit screen display)
Alloy: SS430 TCR: 0.001380 (Set 0138 for a 4 digit screen display - 138 for a 3 digit screen display)
Alloy: SS904L TCR: 0.000734 (Set 0073 for a 4 digit screen display - 073 for a 3 digit screen display)
Alloy: Ni200 TCR: 0.006000 (Set 0600 for a 4 digit screen display - 600 for a 3 digit screen display)
Alloy: Ti1 TCR: 0.003660 (Set 0366 for a 4 digit screen display - 366 for a 3 digit screen display)
Compatibility List available bellow the Rabbit Hole (ATOMIZERS USING THE SAME COILS)
