FreeMaX 904L M Coils (3 Pack)

The 904L M coils are designed for various FreeMaX Sub-Ohm Tanks.

Product Specifications:
904L M1 Single Mesh Coil 0.15ohm 40-70W SS904L (Launched with the M Pro 2 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

904L M1-D Mesh Coil 0.15ohm 50-80W SS904L (Launched with the M Pro 3 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

904L M2 Dual Mesh Coil 0.2ohm 60-90W SS904L (Launched with the M Pro 2 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

904L M3 Triple Mesh Coil 0.15ohm 80-110W SS904L (Launched with the M Pro 2 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

904L M4 Quad Mesh Coil 0.15ohm 70-110W SS904L (Launched with the M Pro 2 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

904L M5 Mixed Mesh Coil 0.15ohm 80-100W 904L & KA1 (Launched with the M Pro 3 Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

Compatibility:
Consult the Atomizers utilizing FreeMaX Mesh Pro Coil Family at the Atomizers Using The Same Coils Category

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

Please Note: Before using Sub-Ohm coils requiring high wattage you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!