Geek Vape Z Coils (5 Pack)

Geek Vape Z Coils are belonging to the Geek Vape Z Coil Family

The Z coils are designed for the Z Sub-Ohm Tank & Z Sub-Ohm Tank 2021.

Product Specifications:
Z Coil 0.4ohm 60-70W KA1 (Launched with the Z Sub-Ohm Tank) - WATTAGE MODE ONLY

Z Coil 0.2ohm 70-80W KA1 (Launched with the Z Sub-Ohm Tank) - WATTAGE MODE ONLY

Z Coil 0.15ohm 80-90W KA1 (Launched with the Z Sub-Ohm Tank 2021) - WATTAGE MODE ONLY

Z Coil 0.25ohm (Dual Coil) 45-57W KA1 (Launched with the Z Sub-Ohm Tank 2021) - WATTAGE MODE ONLY

Z-XM Coil 0.15ohm 70-85W KA1 (Launched with the Z SE Sub-Ohm Tank) - WATTAGE MODE ONLY

Z-XM Coil 0.4ohm 50-60W KA1 (Launched with the Z Fli Sub-Ohm Tank) - WATTAGE MODE ONLY

Z-SS316L Coil 0.15ohm 60-70W SS316L (Launched with the Z Fli Sub-Ohm Tank) - WATTAGE MODE & TEMPERATURE CONTROL

Compatibility:
Consult the Atomizers utilizing Geek Vape Z Coil Family at the Atomizers Using The Same Coils Category

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

Please Note: Before using Sub-Ohm coils requiring high wattage you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!