Innokin PZP Max Coils (3 Pack)

The Innokin PZP Max Coils are initially designed for the Innokin PZPulse Pod.

Product Specifications:
PZP Max Mesh Coil 0.2ohm 18-23W KA1 DL (Launched with the Innokin PZPulse Pod) - WATTAGE MODE ONLY

PZP Max Mesh Coil 0.4ohm 40-60W KA1 DL (Launched with the Innokin PZPulse Pod) - WATTAGE MODE ONLY

PZP Max Mesh Coil 0.6ohm 60-80W KA1 RDL/DL (Launched with the Innokin PZPulse Pod) - WATTAGE MODE ONLY

Compatibility:
Consult the Atomizers utilizing Innokin PZP Max Coils at the Atomizers Using The Same Coils Category (Various Parts, you have to struggle a bit!)

Are all of these coils, working with my compatible AIO Pod System?
Consult the Coil Specs per AIO System Categories (Various Parts, you have to struggle a bit!)

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

Please Note: Before using Sub-Ohm coils requiring high wattage you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!