Geek Vape Plain Wire Spool 30ft

Product Features:
N80 28ga 30ft

N80 26ga 30ft

N80 24ga 30ft

SS316L 28ga 30ft - ALSO TEMPERATURE CONTROL

SS316L 26ga 30ft - ALSO TEMPERATURE CONTROL

SS316L 24ga 30ft - ALSO TEMPERATURE CONTROL

SS430 24ga 30ft - ALSO TEMPERATURE CONTROL

SS430 26ga 30ft - ALSO TEMPERATURE CONTROL

KA1 28ga 30ft

KA1 26ga 30ft

KA1 24ga 30ft

Ti1 28ga 30ft Temperature control ONLY!

Ti1 26ga 30ft Temperature control ONLY!

Ni200 32ga 30ft Temperature control ONLY!

Ni200 28ga 30ft Temperature control ONLY!

Ni200 26ga 30ft Temperature control ONLY!

Please Note: Before building Sub-Ohm coils requiring high wattage / pulling great amount of current, you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

WARNING: It’s EXTREMELY important that you NEVER vape Ni200 or Ti1 coils in Wattage Mode. You might burn them and inhale some very TOXIC fumes. So be careful always and make sure that:
1. You have selected the proper TC Mode - i.e. Titanium Mode for Ti1 coils- when using TC Mode.
2. You have set the PROPER TCR value when using TCR Mode. If TCR value you set is higher than actual, you'll burn the coil(s).

About Plain Wires:
• The lower the gauge (i.e. 20 awg is lower than 22 awg) that means the 20 awg wire has bigger diameter and greater mass than 22 awg for a given length. Greater mass wire for a given length results in lower resistance & requires more power to bring it up to vape temperatures

• The bigger the coil for a given gauge (more wraps, bigger inner diameter), the more power you need. (This will raise your resistance)