SMOK TFV16 Coils (3 Pack)

SMOK TFV16 Coils are belonging to the SMOK TFV16 Coil Family

The TFV16 coils are designed for the TFV16 Sub-Ohm Tank.

They are made of Nichrome (N80) and consist of multiple structurally stable hexagons that enable the mesh wire heating elements to heat more quickly and evenly. Every drop of the e-liquid can be fully heated through these small holes, obtaining more exquisite atomization and restoring the original flavor of e-liquid.

Product Specifications:
TFV16 Mesh Coil 0.17ohm Best 120W N80 (Launched with the TFV16 Sub-Ohm Tank) - WATTAGE MODE ONLY

TFV16 Dual Mesh Coil 0.12ohm 80-160W Best 120W N80 (Launched with the TFV16 Sub-Ohm Tank) - WATTAGE MODE ONLY

TFV16 Triple Mesh Coil 0.15ohm Best 90W N80 (Launched with the TFV16 Sub-Ohm Tank) - WATTAGE MODE ONLY

Compatibility:
Consult the Atomizers utilizing SMOK TFV16 Coil Family at the Atomizers Using The Same Coils Category

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

Please Note: Before using Sub-Ohm coils requiring high wattage you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!