[Boro Format] Vandy Vape Vessel Kit (1 AIO Bridge Coil Boro Pod & 1 AIO RBA Bridge Boro Pod-2 Pods & 2 Coils)

The Vessel AIO Bridge Coil Boro Pod & Vessel AIO RBA Bridge Boro Pod are designed for the Pulse AIO Pod Mod System.

Product Specifications (Vessel AIO Bridge Coil Boro Pod):
Vessel AIO Bridge Coil Boro Pod
5ml Refillable Pod
Side Refill System - Silicone Stoppered
Adjustable Airflow Control - Coil Based Airflow Control Ring

Compatible Devices:
Consult the Boro Format Pod Family at the Pod Systems Using The Same Pods Category

Compatible Coils:
Supports Vandy Vape VVC Coils

* Do not use Stock Coil Boro Pods with Boro AIO Mech Pod Systems. There is a risk of short circuiting and overheating of the battery.

_______________________________________________________________________________________________________________________________________________________________________

Product Specifications (Vessel AIO RBA Bridge Boro Pod):
Vessel AIO RBA Bridge Boro Pod
3.7ml Refillable RBA Pod
Side Refill System - Silicone Stoppered
Adjustable Airflow
Single Coil Build Deck

Compatible Devices:
Consult the Boro Format Pod Family at the Pod Systems Using The Same Pods Category

* RBAs are not suitable for use by those who do not have an understanding of battery safety, Ohms Law & rebuilding

Product (Vessel Kit) Includes:
1 x Vessel AIO RBA Pod

1 x Vessel AIO Pod

2 x VVC Coil

2 x 24ga N80 Coil 0.4ohm

1 x Coil Head Guide

1 x Accessory Bag

How to prime your new coil (Vessel AIO Pod):
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

NOTE (Vessel RBA Pod): It is highly recommended that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.