Geek Vape E100 Pods (2 Pack)

The E100 pods are designed for the Geek Vape E100 AIO Pod Mod System.

Product Specifications:
E100 Pod
4.5ml Refillable Pod
Threaded Top Refill System
Adjustable Airflow Control

Compatibility (Using it as a Pod):
Consult the Geek Vape E100 Pod at the Pod Systems Using The Same Pods Category
Supports Geek Vape P Coils

Compatibility (Using it as a Pod Tank):
Geek Vape E100 Pod Tank fit most 510 threaded devices - The paired device dictates the Ohm limit of your coils
* Do not use it with Mechanical Mods or a hard short might occur which can result in the battery bursting.
Supports Geek Vape P Coils

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.