Geek Vape Wenax C1 Pods (2 Pack)

The Wenax C1 pods are designed for the Wenax C1 AIO Pod System.

Product Specifications:
Wenax C1 Pod
3ml Refillable Pod
Side Refill System - Silicone Stoppered

Compatible Devices/Coils:
Consult the Geek Vape Wenax C1 Pod at the Pod Systems Using The Same Pods Category
Supports Geek Vape G Coil Family (Consult the Geek Vape G Coil Family at the Coil Families (Info) Category)

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.