SMOK RPM160 Pods (Variant Packs)

The RPM160 pods are designed for the RPM160 AIO Pod Mod System.

Product Specifications:
RPM160 V9 Pod
7.5ml Refillable Pod
Side Refill System - Silicone Stoppered
Adjustable Airflow Control - Coil Based Airflow Control Ring

RPM160 Standard Pod
7.5ml Refillable Pod
Side Refill System - Silicone Stoppered

Compatible Devices/Coils:
RPM160 V9 Pod fit for: Consult the SMOK RPM160 Pod at the Pod Systems Using The Same Pods Category
Supports SMOK TFV8 Baby Beast Coil Family (Consult the SMOK TFV8 Baby Beast Coil Family at the Coil Families (Info) Category)

RPM160 Standard Pod fit for: Consult the SMOK RPM160 Pod at the Pod Systems Using The Same Pods Category
Supports SMOK RPM160 Coils

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.