VooPoo Uforce Coils (5 Pack)

The Uforce coils are designed for the Uforce, Uforce T1 & Uforce T2 Sub-Ohm Tank.

Product Specifications:
Uforce U2 Dual Coil 0.4ohm 40-80W best 55-65W (Launched with the Uforce Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce U4 Quadruple Coil 0.23ohm 50-120W best 60-80W (Launched with the Uforce Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce U6 Sextuple Coil 0.15ohm 65-110W best 80-90W (Launched with the Uforce Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce N1 Single Mesh Coil 0.13ohm 50-100W best 70-80W (Launched with the Uforce T1 Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce D4 Quadruple Coil 0.4ohm 50-90W best 65-75W (Launched with the Uforce T2 Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce U8 Octuple Coil 0.15ohm 70-130W best 90-110W (Launched with the Uforce T2 Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce N2 Dual Mesh Coil 0.3ohm 45-80W best 55-65W (Launched with the Uforce T2 Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce N3 Triple Mesh Coil 0.2ohm 65-100W best 75-85W (Launched with the Uforce T2 Sub-Ohm Tank) - WATTAGE MODE ONLY

Uforce P2 Single Mesh Coil 0.6ohm 24-28W (Launched with the Uforce T2 Sub-Ohm Tank) - WATTAGE MODE ONLY

Compatibility:
Consult the Atomizers utilizing VooPoo Uforce Coils at the Atomizers Using The Same Coils Category

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

Please Note: Before using Sub-Ohm coils requiring high wattage you must ensure that your batteries can handle them safely.
Improper use can lead to damage or injury.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!