Geek Vape Mero Pod Tank

The Mero Pod Tank (23mm Base Diameter) consists of a Mero AIO Pod & a 510 threaded pod base adapter.

Product Specifications:
3ml Refillable Pod
Top Refill System - Silicone Stoppered
Adjustable Airflow Control

Product Includes:
1 x Mero AIO Pod
1 x Mero AIO 510 Threaded Pod Base Adapter
1 x B Coil 0.4ohm
1 x Coil Tool

Compatibility (Using it as a Pod):
Consult the Geek Vape Mero Pod at the Pod Systems Using The Same Pods Category
Supports Geek Vape B Series Coils
Supports Mechlyfe OCCBOOST Compact RBA Coil

Compatibility (Using it as a Pod Tank):
Mero Pod Tank fit most 510 threaded devices - The paired device dictates the Ohm limit of your coils
* Do not use it with Faux Hybrid Mechanical Mods or a hard short might occur which can result in the battery bursting.
Supports Geek Vape B Series Coils
Supports Mechlyfe OCCBOOST Compact RBA Coil (The paired device dictates the Ohm limit of your coil build)

* RBAs are not suitable for use by those who do not have an understanding of battery safety, Ohms Law & rebuilding

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Pull out the coil from the pod (If it's pre-installed) and hold it in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on the proprietary Pod Mod System (or assemble the 510 Pod Base Adapter if you want to use it on any 510 threaded Regulated Device) and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

NOTE: It is highly recommended that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.