FreeMaX MS Coils (5 Pack)

Product Specifications:
MS-D Mesh Coil 0.15ohm 60-80W SS904L DL (Launched with the FreeMaX Marvos CRC Pod) - WATTAGE MODE & TEMPERATURE CONTROL

MS-D Mesh Coil 0.25ohm 30-50W SS904L DL (Launched with the FreeMaX Marvos CRC Pod) - WATTAGE MODE & TEMPERATURE CONTROL

MS Mesh Coil 0.15ohm 60-80W SS904L DL (Launched with the FreeMaX Marvos DL Pod) - WATTAGE MODE & TEMPERATURE CONTROL

MS Mesh Coil 0.25ohm 40-55W SS904L DL (Launched with the FreeMaX Marvos DL Pod) - WATTAGE MODE & TEMPERATURE CONTROL

MS Mesh Coil 0.35ohm 30-40W SS904L RDL (Launched with the FreeMaX Marvos DL Pod) - WATTAGE MODE & TEMPERATURE CONTROL

MS Mesh Coil 0.5ohm 20-30W SS904L RDL (Launched with the FreeMaX Marvos DL Pod) - WATTAGE MODE & TEMPERATURE CONTROL

Compatibility:
Consult the Atomizers utilizing FreeMaX MS Coils at the Atomizers Using The Same Coils Category

Are all of these coils, working with my compatible AIO Pod System?
Consult the Coil Specs per System Categories (Various Parts, you have to struggle a bit!)

* As with Pod Tanks, Sub-Ohm Tanks & MTL Tanks, the paired device dictates the Ohm Limit of your coils
Warning: DO NOT use such atomizers with Mechanical Mods or a hard short might occur which can result in the battery bursting.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!