Geek Vape J Series Coils (5 Pack)

The Geek Vape J Series Coils are initially designed for the Geek Vape JR Pod.

Product Specifications:
J Series Mesh Coil 0.4ohm 23-28W KA1 RDL (Launched with the Geek Vape JR Pod) - WATTAGE MODE ONLY

J Series Mesh Coil 0.6ohm 18-25W KA1 RDL/MTL (Launched with the Geek Vape JR Pod) - WATTAGE MODE ONLY

J Series Mesh Coil 0.8ohm 12-18W KA1 MTL (Launched with the Geek Vape JR Pod) - WATTAGE MODE ONLY

J Series Mesh Coil 1.2ohm 8-12W KA1 MTL (Launched with the Geek Vape JR Pod) - WATTAGE MODE ONLY

J Series Mesh Coil 0.3ohm - Coming soon

J Series Mesh Coil 0.2ohm - Coming soon

Compatibility:
Consult the Atomizers utilizing Geek Vape J Series Coils at the Atomizers Using The Same Coils Category (Various Parts, you have to struggle a bit!)

Are all of these coils, working with my compatible AIO Pod System?
Consult the Coil Specs per AIO System Categories (Various Parts, you have to struggle a bit!)

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your atomizer, fill the latter with e-Liquid and take a couple of puffs but with your device off and your airflow open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!

Comment:
Replacement Coils are almost always produced and sold by pack of 5 or pack of 4, of 3 or 2. Sometimes we hear of vendors selling them by the unit - please be aware of this. We do not recommend buying coils by the unit - from a hygiene standpoint - it forces the package to be opened and cut through the sealed packaging. Also when you buy coils by the unit you don't get the scratch-and-check authentication sticker that's on retail box!