[Boro Format] Lost Vape UB AIO Pod (AIO Bridge Coil Boro Pod) (1 Pack)

The UB AIO pods are designed for Boro format AIO Pod Mod Systems.

Product Specifications:
UB AIO Pod
5ml Refillable Pod
Side Refill System - Silicone Stoppered
Adjustable Airflow Control - Coil Based Airflow Control Ring

Compatible Devices/Coils:
Lost Vape Centaurus B60 AIO Pod Mod System (Use coils rated up to 60W & 0.15ohm & above)
Lost Vape Centaurus B80 AIO Pod Mod System (Use coils rated up to 80W & 0.12ohm & above)
Supports Lost Vape UB Coils

* Do not use Stock Coil Boro Pods with Boro AIO Mech Pod Systems. There is a risk of short circuiting and overheating of the battery.

Other Compatible Devices:
Consult the Boro Format Pod Family at the Pod Systems Using The Same Pods Category

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.