Innokin Sensis Pod w/Coils (1 Pod & 2 Coils)

The Sensis pods are designed for the Sensis AIO Pod Mod System.

Product Specifications:
Sensis Pod
3.1ml Refillable Pod
Bottom Refill System - Silicone Stoppered
Adjustable Airflow Control

Product Includes:
1 x Sensis Pod
1 x Sceptre S Mesh Coil 0.25ohm (pre-installed)
1 x Sceptre Mesh Coil 0.65ohm
1 x Spare MTL Drip Tip
1 x Spare O Rings

Compatibility (Using it as a Pod):
Consult the Innokin Sensis Pod at the Pod Systems Using The Same Pods Category
Supports Innokin Sceptre S Coils

Compatibility (Using it as a Pod Tank):
Not available

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Pull out the coil from the pod (If it's pre-installed) and hold it in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!