Lost Vape Orion DNA Plus Pod w/Coils (1 Pod & 2 Coils)

The Orion DNA Plus pods are designed for the Orion DNA Plus AIO Pod System.

Product Specifications:
Orion DNA Plus Pod
2ml Refillable Pod
Threaded Top Refill System

Product Includes:
1 x Orion DNA Plus Pod
1 x Orion DNA Plus Mesh Coil 0.25ohm
1 x Orion DNA Plus Regular Coil 0.5ohm

Compatible Devices/Coils:
Consult the Lost Vape Orion DNA Plus Pod at the Pod Systems Using The Same Pods Category
Supports Lost Vape Orion DNA Plus Coils

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Pull out the coil from the pod (If it's pre-installed) and hold it in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!