[dotAIO Format] dotMod dotAIO Tank (AIO Bridge Coil/AIO RBA Bridge dot Pod) (1 Pack)

The dotAIO pods are designed for the dotAIO AIO Pod System.

Each of these pods feature a 2.7ml e-juice capacity, single 6mm by 4mm fill port and coil adapter for Aspire Nautilus BVC coils. Without the use of the coil adapter users may enjoy a flavorful vaping experience with the dotAIO replacement coils. With the gold plated accents on this replacement pod completely match the visually stunning aesthetic of dotMod Devices.

Product Specifications:
dotAIO Pod
2.7ml Refillable Pod
Side Refill System - Silicone Stoppered
Adjustable Airflow Control - Coil Based Airflow Control Ring
Included Coil Adapter for Aspire Nautilus BVC Coils

Compatible Devices:
Consult the dotAIO Format Pod Family at the Pod Systems Using The Same Pods Category

Compatible Coils:
Supports dotMod dotAIO Coils
Supports dotMod dotAIO RBA Coil
Supports Aspire Nautilus Coil Family (Requires Adapter) (Consult the Aspire Nautilus Coil Family at the Coil Families (Info) Category) Warning: Do not use the Triton Mini Ni200 Coil because it requires Nickel Mode/TCR Mode!**

Compatible Pods:
Consult the dotAIO Format Pod Family at the Pod Families (Info) Category

* WARNING: It’s EXTREMELY important that you NEVER vape Ni200 or Ti1 coils in Wattage Mode. You might burn them and inhale some very TOXIC fumes.

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Hold the coil in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on your device and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!
* If your device utilizes auto draw function with no turn-off option, fill the pod with e-Liquid and take a couple of puffs before you install it on device.