VooPoo PnP-X Pod Tank

The PnP-X Pod Tank (24mm Base Diameter) consists of a PnP-X Pod & a 510 Magnetic pod base adapter.
The VooPoo PnP-X pod tank is an innovative vape tank which can be used as a replacement pod for various VooPoo Pod Mod Systems or as a standard 510 Sub-ohm tank with the use of a metal plate 510 base adapter. To use as a tank, simply install the 510 magnetic base adapter which comes included, which allows the tank to be paired with the majority of vape mods.

Product Specifications:
PnP-X Pod
5ml Refillable Pod
Side Refill System - Silicone Stoppered
360-degree Adjustable Airflow Control

Product Includes:
1 x PnP-X Pod
1 x PnP-X 510 Magnetic Pod Base Adapter (Pre-Installed)
1 x PnP TM2 Coil 0.8ohm
1 x PnP VM6 Coil 0.15ohm
1 x PnP-X MTL Drip Tip
1 x User Manual

Compatibility (Using it as a Pod):
Consult the VooPoo PnP Pod Family at the Pod Systems Using The Same Pods Category
Supports VooPoo PnP/GTX Coil Family (Consult the VooPoo PnP/GTX Coil Family at the Coil Families (Info) Category)

Compatibility (Using it as a Pod Tank):
VooPoo PnP-X Pod Tank fit most 510 threaded devices - The paired device dictates the Ohm limit of your coils
* Do not use it with Faux Hybrid Mechanical Mods or a hard short might occur which can result in the battery bursting.
Supports VooPoo PnP/GTX Coil Family (Consult the VooPoo PnP/GTX Coil Family at the Coil Families (Info) Category)

* RBAs are not suitable for use by those who do not have an understanding of battery safety, Ohms Law & rebuilding

How to prime your new coil:
New coils must ALWAYS be fully saturated before FIRST use, otherwise the cotton inside will be burned.
Pull out the coil from the pod (If it's pre-installed) and hold it in your hand and drip not just a few drops of e-Liquid but the required amount (Dependent on the coils' size) directly into the top hole. Do this on an angle, so that the cotton on the inner wall absorbs the e-Liquid. Next, start dripping some e-Liquid into the holes on the sides of your coil. There may be 2 or more drops for each hole, and you’ll notice that the e-Liquid is quickly absorbed by the cotton. You’ll want to make sure that you keep dripping into these holes until it stops absorbing it. Install the coil into your pod, fill the latter with e-Liquid, install the pod on the proprietary Pod Mod System (or assemble the 510 Pod Base Adapter if you want to use it on any 510 threaded Regulated Device) and take a couple of puffs but with your device off. If the airflow is adjustable, make sure it's open. Don’t inhale too hard. Just inhale as if you’re taking a normal draw. Your coil is fully saturated!